Biostar TF7100P-M7 Manuel d'utilisateur télécharger pdf (Page 22)

TF7150U-M7 / TF7100P-M7

On-chip IDE Channel 0

The motherboard chipset contains a PCI IDE interface with support for two

IDE channels. Select “Enabled” to activate the first and/or second IDE interface.

Select “Disabled” to deactivate an interface if you are going to install a primary

and/or secondary add-in IDE interface.

The Choices: Enabled (default), Disabled.

Primary Master/Slave PIO

The IDE PIO (Programmed Input / Output) fields let you set a PIO mode (0-4)

for each of the IDE devices that the onboard IDE interface supports. Modes 0

to 4 will increase performance progressively. In Auto mode, the system

automatically determines the best mode for each device.

The Choices: Auto (default), Mode0, Mode1, Mode2, Mode3, Mode4.

Primary Master/Slave UDMA

Ultra DMA function can be implemented if it is supported by the IDE hard

drives in your system. As well, your operating environment requires a DMA

driver (Windows 95 or OSR2may need a third party IDE bus master driver). If

your hard drive and your system software both support Ultra DMA, select Auto

to enable BIOS support.

The Choices: Auto (default), Disabled.

IDE DMA Transfer Access

This item allows you to enable or disable the IDE DMA transfer access.

The Choices: Enabled (default), Disabled.

Serial-ATA Controller

This item allows you to control the SATA controller.

The Choices: Enabled (default), Disabled.

IDE Prefetch Mode

The “onboard” IDE drive interfaces supports IDE prefetch function for faster

drive access. If the interface on your drive does not support prefetching, or if

you install a primary and/or secondary add-in IDE interface, set this option to

“Disabled”.

The Choices: Enabled (default), Disabled.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Pas de commentaire

Biostar TF7100P-M7 Manuel d'utilisateur Page 22