Biostar I915P-A7 Manuel du propriétaire télécharger pdf (Page 54)

I915P-A7 BIOS Manual

5.3 Supe r IO De vice

If you highlight the literal “Press Enter” next to the “Super IO Device” label and then press the

enter key, it will take you a submenu with the following options:

5.3.1 Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed on the system

board and you wish to use it. If install and FDC or the system has no floppy drive, select

Disab led in this f ield.

The Choices: Enabled (default), Disabled.

5.3.2 Onboard Serial Port 1

Select an address and corresponding interrupt for the first and second serial ports.

The Choices:Disabled, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Auto.

5.3.3 Onboard Serial Port 2

Select an address and corresponding interrupt for the first and second serial ports.

The Choices:Disabled, 2F8/IRQ3 (default), 3F8/IRQ4, 3E8/IRQ4,

2E8/IRQ3, Auto.

5.3.4 UART Mode Select

This item allows you to determine which Infra Red (IR) function of onboard I/O chip.

The Choices:Normal (default), AS KIR, IrDA.

5.3.5 UR2 Duplex Mode

elect the value required by the IR device connected to the IR port. Full-duplex mode

permits simultaneous two-direction transmission. Half-duplex mode permits transmission

in one direction only at a time.

The Choices: Half (default), Full.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 65 66

Pas de commentaire

Biostar I915P-A7 Manuel du propriétaire Page 54