Biostar I915P-A7 Manuel du propriétaire télécharger pdf (Page 14)

I915P-A7

2.4 CONNECTORS AND SLOTS

FDD1: Floppy Disk Connector

The motherboard provides a standard floppy disk connector that supports

360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector

supports the provided floppy drive ribbon cables.

IDE1/IDE2/IDE3: Hard Disk Connectors

(IDE2/IDE3 are optional.)

The motherboard has a 32-bit Enhanced PCI IDE Controller that provides

PIO Mode 0~5, Bus Master, and Ultra DMA 33/ 66/ 100 functionality. It has

two HDD connectors IDE1 (primary) and IDE2 (secondary).

The IDE connectors can connect a master and a slave drive, so you can

connect up to four hard disk drives. The first hard drive should always be

connected to IDE1.

PCI 1~PCI3: Peripheral Component Interconnect Slots

This motherboard is equipped with 3 standard PCI slots. PCI stands for

Peripheral Component Interconnect, and it is a bus standard for expansion

cards. This PCI slot is designated as 32 bits.

SATA1~SATA4: Serial ATA Connectors

The motherboard has a PCI to SATA Controller with 2 channels SATA

interface, it satisfies the SATA 1.0 spec and with transfer rate of 1.5Gb/s.

Pin Assignment Pin Assignment

1 Ground 2 TX+

3 TX- 4 Ground

5 RX- 6 RX+

7 Ground

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 65 66

Pas de commentaire

Biostar I915P-A7 Manuel du propriétaire Page 14