Biostar I915P-A7 Manuel du propriétaire télécharger pdf (Page 23)

I915P-A7

23

4.3 TROUBLESHOOTING

Probable Solution

1. No power to the system at all

Power light don’t illuminate, f an

inside power supply does not turn

on.

2. Indicator light on key board does

not turn on.

1. Make sure power cable is

securely plugged in.

2. Replace cable.

3. Contact technical support.

System inoperativ e. Keyboard lights

are on, power indicator lights are lit,

and hard driv e is spinning.

Using even pressure on both ends of

the DIMM, press down firmly until the

module snaps into place.

System does not boot from hard disk

driv e, can be booted f rom optical driv e.

1. Check cable running from disk to

disk controller board. Make sure

both ends are securely plugged

in; c hec k t he driv e ty pe in t he

standard CMOS setup.

2. Backing up the hard drive is

extremely important. All hard

disks are capable of breaking

down at any time.

System only boots f rom optical driv e.

Hard disk can be read and applications

can be used but booting from hard disk

is impossible.

1. Back up data and applications

files.

2. Ref ormat the hard driv e.

Re-install applications and data

using backup disks.

Screen message says “Invalid

Conf iguration” or “CMOS Failure.”

Rev iew system’s equipment. Make sur

e

correct inf ormation is in setup.

Cannot boot system after installing

second hard driv e.

1. Set master/slave jumpers

correctly.

2. Run SETUP program and select

correct driv e types. Call the drive

manuf acturers f or compatibility

with other drives.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 65 66

Commentaires sur ces manuels

Pas de commentaire